Kenco-engineering Thermal Differential Switch Uživatelský manuál Strana 1
Procházejte online nebo si stáhněte Uživatelský manuál pro Senzory Kenco-engineering Thermal Differential Switch. Kenco Engineering Thermal Differential Switch User Manual Uživatelská příručka
- Strana / 8
- Tabulka s obsahem
- KNIHY
Shrnutí obsahu
Page 1 KENCO ENGINEERING COMPANY P.O. BOX 470426 TULSA, OK 74147-0426 ● PHONE: (918) 663-4406 FAX: (918) 663-4480 www.kenco-eng.com e-mail: info@ken
Page 2 GENERAL DESCRIPTION The Series KTD Thermal Differential Switch is the state-of-the-art in gaseous and liquid flow switching or liquid level / i
Page 3 INSTALLATION Unpack the switch carefully. Inspect all units for damage. Report any damage to carrier immediately. Check the contents against
Page 4 Electrical Installation It is recommended that conduit be installed onto the ¾” NPT connection on the electronics housing. A seal drain fittin
Page 5 4. Pull the power/signal wires through the conduit opening. 5. Connect Power and relay wiring to Terminal Block (TBB) see figure on
Page 6 J2 – This sets the Failsafe condition of the switch. The jumper should cover the (2) left-most pins for High Level Failsafe (HLFS) conditi
Page 7 CALIBRATION (Flow Switch) (Refer to Page #5 for location of controls) NOTE: For optimum performance, the calibration must be do
Page 8 MAINTENANCE & TROUBLESHOOTING The sensor can be cleaned by soaking, spraying or ultrasonic cleaning. Verify material compatibility before
Související produkty a manuály pro Senzory Kenco-engineering Thermal Differential Switch
(30 stránky)© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.051 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce